易发彩登陆

Current Location:Home » News » Company news » Common failure analysis and solution of plate bending machine
News
Tel:15853263376 13206477177
Landline:0532-88269678
fAX:
E-mail:
News
Common failure analysis and solution of plate bending machine
Adding time:2019-04-23 Browse times: 42

  The plastic sheet bending machine is the same as the general sheet bending machine。 It mainly consists of a bracket, a table and a clamping plate。 The table is placed on the bracket。 The table is composed of a base and a pressure plate。 The base is hinged and clamped。 The plates are connected, and the base is composed of a seat shell, a coil and a cover plate, and the coil is placed in the recess of the seat shell, and the top of the recess is covered with a cover plate。

易发彩登陆   Any mechanical equipment will have some faults during use, and the plastic sheet bending machine is no exception。 Below, Qingdao Yifei gives several common faults for everyone, and analyzes the causes and troubleshooting methods。

  1。 The oil pump does not produce oil。 The slider does not move。

易发彩登陆   Cause: The oil pump is rotating in the wrong direction.

  Remedy: phase proofing the power supply line

  2。 Components, pipe joints, that is, leakage of the cylinder

  Cause: Damage or aging of the seal

  Remedy: Replace the seal

  3. Pipe and machine vibration

  Cause: The fuel tank is not enough or the oil net is blocked, so that the suction pipe is sucked up。

  Remedy: Clean the oil filter net or the mailbox to the oil mark center

  4. The oil circuit can not establish pressure

  Cause: The solenoid valve does not change direction or the relief valve such as the overflow valve and the oil filling valve are stuck.

  Remedy: Plug the electrical plug of the solenoid valve to prevent looseness, remove the spool cleaning

  5. The slider can't stop at any position, there is a sliding phenomenon

  Cause: the spool is stuck

  Remedy: Electric cleaning spool

  6. The slider is falling too fast or too slow

易发彩登陆   Cause: The amount of opening of the cone valve is too large or too small

  Remedy: Electric adjustment

  7。 The moment the slider returns, the sound is generated。

  Cause: The moment the slider returns, the sound is generated.

  Remedy: Check the adjustment time relay time

Key wordBrowse times:42
New products

Tel:15853263376 13206477177
E-mail:


Copyright © 2019-2035 Qingdao Brothers Union won the Plastic Welding Equipment Co.,Ltd. Record number:鲁ICP备19014703号-1
内蒙古快3 易发彩网址是多少 幸运时时彩 浙江福彩网 全民彩票 重庆龙虎和微信群 江苏快三走势图 网娱棋牌 易发彩官网 福建快3走势